Torsion spring machine no-load test run

Posted by Admin

1. First start the rotation of the torsion spring machine to check whether the components are normal. Whether the voltage is stable or not, after checking the Z-axis, check whether the Z-axis rotation is stable and there is no twisting. No load operation before leaving the factory must be idle for 4-8 hours.
2. Check if the torsion spring machine has a grounding wire to prevent the leakage point from happening, so as to avoid unnecessary occurrence.
3. Adjust the controller to manual operation and use the Y-axis motion repeatedly to see if the Y-axis operation is stable and easy.
4. Check the following items during the rotation of the torsion spring machine:
a: The lubrication points of the transmission gears and bearings are fully lubricated, and the sealing parts are well sealed.
b: There must be no large vibration and periodic noise during operation.

Related Products