How does the compression spring machine wind the tower spring?

Tower spring is one of the more widely used spring products in the industrial industry. At this stage, most of the hardware accessories or spring factories often produce this kind of spring products. Warm reminder, according to the structural characteristics of the tower spring itself, we have to select a relative compression spring machine for debugging and winding. So, how to debug the compression spring machine to wind the tower spring?

① Observe the structural characteristics of the tower spring and master the pitch of the starting point. In the whole process of debugging, the pitch of the spring should be opened or closed in a certain circle. The root cause of this spring is generally skew in a certain direction after it is settled. Therefore, we must pay attention to this point in the actual operation of using the compression spring machine to wind the tower spring.

②Grasp the winding characteristics of the tower spring and manipulate the change of diameter. Since the tower spring is variable in the whole process of winding, it is necessary to adjust the diameter of the gap during the actual debugging operation, and then install the variable diameter camshaft and adjust the proportional lever for service. Not only must the spring be manipulated properly. As the diameter changes, the spacing between the coils must also be adjusted.

③In the whole process of debugging the tower spring, it is necessary to grasp the overall height of the prefabricated component. In the whole process of using the compression spring machine to debug and wind the tower spring, according to the control of the pitch and the adjustment of the diameter, the overall height of the tower spring is controlled and adjusted for this purpose. Suppose you want to grasp the market price of compression spring machines.

④Adjust the diameter of each coil to ensure the flatness and coaxiality. In the whole process of debugging and winding the tower spring, it is especially important to pay attention to the specification of its middle diameter. When debugging, it is necessary to go through continuous attempts to clarify the size of each diameter, such as the effective statistics of the short head diameter, the middle diameter, the large end diameter, and the height of the prefabricated parts. Otherwise, the spring will be protruding because of the middle diameter after it is set. In turn, the flatness and coaxiality of the spring itself are endangered.
In addition, the tower spring must bear the necessary working pressure when in use. The two sides of the structure are divided into open, closed, and winding methods. Because of the different cross-sections of the raw materials, they are divided into ring, rectangular frame and multiple The core steel is wound around; due to the difference in pitch, it is divided into equal pitch and variable pitch. Therefore, in the whole process of winding the tower spring, we can refer to the solution described and give full play to the role of the compression spring machine.