News -

Home / News (Page 16)

What should I do if the computer spring machine suddenly leaks?
27 Jul 2019
1. Connect the machine to the household iron water pipe with a common electric wire. If the power supply has a grounding wire, connect the power ground wire of the machine, use an iron bar to insert it to the ground about one meter deep, and then wir...
Spring machine computer controller common fault
19 Jul 2019
The common faults of the spring machine computer controller are listed as follows: 1. Turn on the computer motor will automatically run, the controller to the drive control line welding error or the motor to the driver's encoder line welding error. 2...
Computer spring machine frame failure
13 Jul 2019
1. The computer spring machine turns off the power, opens the wire frame door, and most of the wire frame circuit is installed on the door. Check carefully to see if there is any loose terminal, which may cause poor line contact. Please tighten the f...
Computer spring machine quality assessment standards.
05 Jul 2019
1. The operability of the computer spring machine, whether it is easy to operate, whether the appearance of the machine is beautiful, whether the chamfered part of the part is in place, whether it will accidentally injure the operator, whether it is ...
Eight reasons why spring manufacturers use computer spring machines
29 Jun 2019
1. The four axes of the spring machine are controlled by computer, which can be operated separately or in combination. The angle of rotation of the cam can reach 0.1 degree. 2. After the wire feeding device is placed horizontally on the machine, each...
What are the deficiencies of mechanical spring machines?
15 Jun 2019
1, Wire feeding accuracy / length In terms of power source, the mechanical spring machine's wire feeding power uses ordinary three-phase/single-phase motors, which are characterized by uncontrolled angle. 2, Electromagnetic clutch / one-way clutch Du...
Spring production equipment operation process
31 May 2019
1. Firstly, the grinding sleeve is matched according to the height requirement of the equipment, and the height of the grinding sleeve should be slightly lower than the height of the Spring equipment, about 3 mm, and then the height of the grinding w...
What does the "axis" of the computer spring machine mean?
17 May 2019
The "axis" of the computer Spring machine represents the coupling transmission between the supporting components, combined with the driving mode of the servo motor, to represent the number of servo motors. For example, the universal spring machine is...

Products
Tel
Email
Order
Share

Products

Products

Feedback

Please leave your Email or phone nomber, so we can contact you as soon as possible.